sms send & recieving using pic16f84

[ruwan]

thank you mr gioppy.
i following that forums.ican,n understand quekly.i will try it

pic basic and pic basic pro are same lanauge.
thank you

[ruwan]

hello.
can you write me simple exmple.this one.i want to automaticaly send massag "hello" .16f84 portb.0 input signal.
(tell me first i am this masage save in phone.then i writ program pic using at command.then send phone using data reciving pin)
sorrey for my bad english.

[ruwan]

thanks for all.to help me.

[Ioannis]

I hope you are not being ironic...

In case you don't, I have to say that such a project is not simple or for the novice. You must have a good understanding of serial communication and can suggest few books to read and of course hardware knoledge of the devices you are going to use.

In the case of mobiles, you have to do 2 way communication with the device under control to make sure that all your settings are processed. Even a single AT must be replied with an OK and your PIC should received it before sending any new commands.

Also every phone/module have additional commands special to itself.

If you have written some code but want to check it or debug it, feel free to post it here.

Ioannis

[ruwan]

i have a ericsson gf768 phone . i can,t find a t10 phone .