Problem with manchester code for RF

[Dave]

dhouston, I call that type if "error detection" signal integrity, not error detection. You could have a noise source producing edge changes at the same rate as the baud rate you are trying to detect. Where is the error detection then?

Dave Purola,
N8NTA

[dhouston]

dhouston, I call that type if "error detection" signal integrity, not error detection. You could have a noise source producing edge changes at the same rate as the baud rate you are trying to detect. Where is the error detection then?

Call it what you like. I'll call it what it is.

[dhouston]

You could have a noise source producing edge changes at the same rate as the baud rate you are trying to detect. Where is the error detection then?

And where is the error if no low state gets changed to a high state?

[Dave]

dhouston, Try deciphering 1 individual transmission of 128 data bits (256 states) with 4 or more transmitters being keyed at the same time.... The data states at the receiver might look good but what about the actual data..... Like I said... Signal integrity

Dave Purola,
N8NTA