*jumps up and down for joy* I... I have done it!


And now I will explain how. First of all many thanks to everyone for the help!

First I will mention that I am using MicroPro and the 149c DIY programmer.

After explorer fuses a bit, I found that through micropro I could tell what the fuses were set to, and so. I was able to change the fuse to INTRC_IO on the programmer. And I did not have to make any device calls in pbp at all.

With this osilator set to INTRC_IO it just worked.

It may be worth mentioning that the pbp default seems to be HS.

Anyways thankyou all again!