Well... I do not use MicroCode Studio very often. In fact the version I have is copyright 2001,2003. I could never get it to work correctly with my programmer (PICKIT1 when I started and soon after PICSTART PLUS). Would use MicroCode Studio set up to compile with with Micro Chip MPASM, then use MPLAB to burn the chip. A pain but...

Then MPLAB 7.00 came out and microEngineering Labs came out with this
http://melabs.com/support/mplab.htm
All was well now, PBP inside of MPLAB!!

As for the configuration, I make the changes I need in the PBP *.inc file for that chip. Most often for me on any given chip this will stay the same and if a change is needed for a certain project I will make a note of it.

In the PBP *.inc file you will find a line for the PM header and another line for the MPASM header.

Thats how I do it, but I am sure there are other ways. Here is an interesting thread. http://www.picbasic.co.uk/forum/show...ighlight=MPLAB

Let us know how it goes.