Driving a mosfet directly?


Results 1 to 22 of 22

Threaded View

  1. #1
    Join Date
    May 2007
    Posts
    66

    Default Driving a mosfet directly?

    I would like to use a power mosfet IRFP460 to switch a 24V circuit.
    The IRFP460 is a n-channel mosfet with the following rating:
    Vdss = 500 V
    Id(cont) = 20A
    Rds(on) = 0.27 ohm
    Vgs(th) = min 2V max 4V
    Vgs continuous gate-to-source 20V

    Can I drive this mosfet by connecting the gate directly to my PIC16F73 output port or do I need a mosfet driver?
    Also, can I connect the mosfet source directly to the ground of the 24V supply, and drain goes to load with other side of load going to +24VDC?
    If a driver is needed, can you recommend a suitable driver.
    If a driver is not needed, is it then necessary to put a resistor inbetween I/O pin and gate and if so, what size?
    Any help is appreciated.
    Last edited by passion1; - 8th July 2007 at 20:10.

Similar Threads

  1. Another Mosfet Question
    By tazntex in forum General
    Replies: 14
    Last Post: - 29th September 2008, 03:53
  2. Help needed - MOSFET driven by PWM
    By bcd in forum mel PIC BASIC Pro
    Replies: 8
    Last Post: - 2nd April 2008, 05:02
  3. Mosfet problems
    By Agent36 in forum General
    Replies: 7
    Last Post: - 2nd February 2008, 22:37
  4. MOSFET control using PWM & 16C711?
    By droptail in forum mel PIC BASIC Pro
    Replies: 6
    Last Post: - 27th June 2005, 02:24
  5. Driving a logic-level HEXFET
    By thelightbrain in forum mel PIC BASIC Pro
    Replies: 1
    Last Post: - 10th November 2004, 23:34

Members who have read this thread : 0

You do not have permission to view the list of names.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts