Slot Car timer with pic 16f84a

[skimask]

Use a shorter pause inside a loop (for temp = 0 to 1000 : pause 1 : check for another car here : next temp ) while checking for a 2nd car, set a flag (or flags), then when the tight-loop-pause exits, check the flag to see if another notice has to be sent out, then reset the flag.

[Snap]

Thank you for your reply,
I have not done flags before I will have to research them. I get what you are saying about small loops inside of loops but would like to know if there are any examples out there to study from.

[skimask]

Thank you for your reply,
I have not done flags before I will have to research them. I get what you are saying about small loops inside of loops but would like to know if there are any examples out there to study from.

Example right there in my last post...
Your one second pause =
Pause 1000

Another way to do it, and to check stuff in between...
For temp = 1 to 1000
Pause 1
'check for other stuff
Next temp

Of course the looped way of doing it will always end up being over one second, so you might end up having to use 900 instead of 1000 depending on how much 'check for other stuff' you do.
Past that, you could always learn about interrupts and use those as you initially suggested.

But, I'd suggest you get rid of that POT command and whatever light sensing resistors you're using and switch over to some sort of 'beam breaking' method or maybe a magnetic reed switch since slot cars tend to have magnets in them (don't they?). The POT command takes too much time with what you want to do, and it's a show stopping command. When the POT command is executing, nothing else is, hence you miss a second car while trying to sense the first.
With the beam breaking method, you can instantly scan multiple lanes and put each beam break into a queue with a time stamp and send the information out the serial port when you want.

[Snap]

Thank you for all your help. I nested a few small loops and it worked like a charm....except for like you said when a very fast car goes by when the other lane is potting it can miss it. It happens rarley but it happens. I am set up with the light sensors secured in the track and I built a light source above them so I am going to work on keeping them somehow. (reed switches would work but I also know that other people have made the light sensors work) I will start researching light sensing circuits tomorrow. But in the mean time Thank again for the advice.
Snap