How to add programmer?

[danneskjold]

Hi Charles

Thanks for the reply. I've been using the MPLAB import procedure up to this point. I was hoping there was a better way. Thanks for trying.

[mister_e]

You can still use PBP within MPLAB if you install the language toolsuite plugin.
http://www.melabs.com/support/mplab.htm

But, there's no real advantage over MicroCode Studio

[G-R-C]

I think there might be a better way. Recently purchased an ICD 2 clone
and set MPLAB to work with PBP. Its take a little work and some careful
instructions (not to mention it was little hard to find), but give this site
a try. I think its what your looking for.

http://www.blueroomelectronics.com/inchworm.htm

Look towards the bottom of the page there will be link that will
take you to a site that walks you through the procedure of how
to make PBP and MPLAB work together (which also let us the ICD2).

Hope this helps

[G-R-C]

Ahh, better yet, here is the actual link to the step by step
guide.

http://melabs.com/support/mplab.htm

You will use MPLAB but it will acept PBP code. This will let you
use your ICD2 to program you PIC.

Good Luck