New to this, Need some starter help

[power_speed]

I now know what was up. The microcode studio software found the old picbasic that was still installed. I was trying to use picbasic pro commands and it was trying to compile using the picbasic only. I changed that AND no more errors.

Thank you for your assistance.

I would still like to know though will the peek command read pins and ports?

[skimask]

I now know what was up. The microcode studio software found the old picbasic that was still installed. I was trying to use picbasic pro commands and it was trying to compile using the picbasic only. I changed that AND no more errors.

Thank you for your assistance.

I would still like to know though will the peek command read pins and ports?

The answer awaits you in the manual.

[power_speed]

Yep your right about that. Manual is my new best friend as I proceed onward.

[skimask]

Yep your right about that. Manual is my new best friend as I proceed onward.

I take it that you found the answer to all your questions...at least until next time, yes?

[power_speed]

Yep all is going well now, except for the if then else things. IT keeps telling me that i have a 'then' not preceeded by an if. Also 'else' not proceeded by an if or a then.

I suppose A little more study will be required to figure this one out.

[skimask]

Yep all is going well now, except for the if then else things. IT keeps telling me that i have a 'then' not preceeded by an if. Also 'else' not proceeded by an if or a then.

I suppose A little more study will be required to figure this one out.

Well then, try this:

IF you post your code THEN
somebody around here might be able to help you
ELSE
nobody will be able to figure out what you're trying to do
ENDIF

[power_speed]

I figured out the if then else thing. The manual listed the else on the same line as the if. That is how I put it. Moved the then to the next line and all is well.