New to this, Need some starter help

[power_speed]

W0 var word
highin var PORTB 'for input of the inputs pins

PEEK PORTB, W0 'to take a look at port b and see if
'if any inputs are high.


Here are some of the errors I am getting.

ERROR Line 12: ':' or '=' Expected (Token 'var') (Security.pbc)
ERROR Line 13: ':' or '=' Expected (Token 'var') (Security.pbc)
ERROR Line 15: Variable or Constant Expected (Token 'PORTB') (Security.pbc)
ERROR Line 15: End of Line or ':' Expected (Token ',') (Security.pbc)


So far this is as far as I have gotten. I am confident that If I can solve these errors I will be better off than I was before.

[skimask]

W0 var word
highin var PORTB 'for input of the inputs pins
PEEK PORTB, W0 'to take a look at port b and see if
'if any inputs are high.

Here are some of the errors I am getting.

ERROR Line 12: ':' or '=' Expected (Token 'var') (Security.pbc)
ERROR Line 13: ':' or '=' Expected (Token 'var') (Security.pbc)
ERROR Line 15: Variable or Constant Expected (Token 'PORTB') (Security.pbc)
ERROR Line 15: End of Line or ':' Expected (Token ',') (Security.pbc)

So far this is as far as I have gotten. I am confident that If I can solve these errors I will be better off than I was before.

Are you using PicBasicPro or PicBasic? Where did you buy it from?

And I suggest you start off with the standard Blinky LED project if you're just getting into PBP. Get that done and you'll be a lot better off...

[power_speed]

I now know what was up. The microcode studio software found the old picbasic that was still installed. I was trying to use picbasic pro commands and it was trying to compile using the picbasic only. I changed that AND no more errors.

Thank you for your assistance.

I would still like to know though will the peek command read pins and ports?

[skimask]

I now know what was up. The microcode studio software found the old picbasic that was still installed. I was trying to use picbasic pro commands and it was trying to compile using the picbasic only. I changed that AND no more errors.

Thank you for your assistance.

I would still like to know though will the peek command read pins and ports?

The answer awaits you in the manual.

[power_speed]

Yep your right about that. Manual is my new best friend as I proceed onward.

[skimask]

Yep your right about that. Manual is my new best friend as I proceed onward.

I take it that you found the answer to all your questions...at least until next time, yes?

[power_speed]

Yep all is going well now, except for the if then else things. IT keeps telling me that i have a 'then' not preceeded by an if. Also 'else' not proceeded by an if or a then.

I suppose A little more study will be required to figure this one out.