PIC16F84A EEPROM problems

**The Master** · - 11th June 2007, 20:44

ok, i copied that exactly. it wouldnt compile because of the top line so i removed it and set the fuses in the programmer software. i borrowed one of those caps from another circuit and its still not working. im getting the exact same result

Edit: MCLR is connected to vdd with a 10K resistor

**mister_e** · - 11th June 2007, 20:48

OK, so what happen if you change the loop to

Code:

        for Addr=0 to 7
            PORTB = DCD ADDR
            PAUSE 500
            NEXT

If it doesn't work... or you have a faulty crystal, or your crystal capacitor are bad, or the PSU is bad, or the PIC is bad... OR everything previously listed

EDIT: config fuses..
http://www.picbasic.co.uk/forum/showthread.php?t=543

**The Master** · - 11th June 2007, 20:55

[QUOTE=mister_e;39699]OK, so what happen if you change the loop to

Code:

        for Addr=0 to 7
            PORTB = DCD ADDR
            PAUSE 500
            NEXT

that works. the LEDs are chasing as expected. what does this mean then?

**mister_e** · - 11th June 2007, 20:58

Probably the PIC EEPROM is bad OR there's a setting in your device programmer software that you overlooked.

What i mean is that some Device programmer software allow to program OR NOT the PIC EEPROM. Sure it's something like that.

**The Master** · - 11th June 2007, 21:08

Originally Posted by mister_e

Probably the PIC EEPROM is bad OR there's a setting in your device programmer software that you overlooked.

What i mean is that some Device programmer software allow to program OR NOT the PIC EEPROM. Sure it's something like that.

right. ive just tested it on another chip so its not that. theres 1 more fuse value you didnt mention so i changed that. the programmer app has an EEPROM override button so i tried that too and still as before.

this is confusing. random thought, could this possibly be anything like those chips where you have to access the *internal* EEPROM asif it was *external*?

another thing is that the datasheet for this chip says EEPROM stuff has to be written in a certain way but it only gives examples of assembly code so i dont understand it

**mister_e** · - 11th June 2007, 21:11

compile the first example the send me the generated .HEX file (in a .ZIP)

Everything work as expected here.

Which PIC programmer and software do you use?

EDIT: Which PBP version ?

**The Master** · - 11th June 2007, 21:15

Originally Posted by mister_e

compile the first example the send me the generated .HEX file (in a .ZIP)

Everything work as expected here.

Which PIC programmer and software do you use?

ok, this is the first example without the first line (or it wont compile)

the programmer i think is DIY K149 or 3149B-E
the programmer software is micropro25

Edit: Microcode studio 2.2.11 / PICBASIC PRO 2.45