Model Rocket Launcher Help

[viewgsm]

Hi

I agree with Acetronics
also this PULL-DOWN will not help if the pin went high for low time ,
this will help to keep your PIN pulled to the ground (NOT FLOOATING) in case the pin was setuped as input or AN .

good luck

[BigWumpus]

After any reset the Pins will be set as input - for you, they will be tristate!
So, add the pull-down-resistor an write a good programm !

[manumenzella]

Hi there. Thanks a lot for all your answers!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Its great to be able to ask for help and get it so quick!!!!
I will use the pull-down resistor and be sure to configure the port to output low.
Thanks a lot again! Great forum!
Manuel