Model Rocket Launcher Help

[BobK]

Hi Manuel,

You should check the nuts & volts website as a model rocket launcher was a PIC project I believe early in 2006.

I was looking into building a couple for my grandsons that was fully automatic with an ISD chip providing the countdown over a loud speaker adding the various system checks. I thought of using a relay to prevent accidental ignition. Have it wired normally open until a specific point in the countdown then if the other safety checks were okay then the relay would be switched on enabling launch voltage ready for the count to reach zero.

I was heavy into rocketry as a kid myself! Have fun.

BobK

[Acetronics2]

Hi, Manu

It's a VERY common Pic issue : defining pin states at power up ...

so, it's easy but relatively unknown ...

1) Write your output intial state : PORTx = % 00110010 i.e.

2) Select input or output : TRISx = % 11000001 i.e.

yes ... so simple as this !!!

Alain

[viewgsm]

Hi

I agree with Acetronics
also this PULL-DOWN will not help if the pin went high for low time ,
this will help to keep your PIN pulled to the ground (NOT FLOOATING) in case the pin was setuped as input or AN .

good luck

[BigWumpus]

After any reset the Pins will be set as input - for you, they will be tristate!
So, add the pull-down-resistor an write a good programm !

[manumenzella]

Hi there. Thanks a lot for all your answers!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Its great to be able to ask for help and get it so quick!!!!
I will use the pull-down resistor and be sure to configure the port to output low.
Thanks a lot again! Great forum!
Manuel