It's a 16F628 and I think it's OK. (unless the lot was trash) I have shorted the base/emitter junction of the 2N3906 driver transistor for the LED and it comes on every time. I'll check the gating for the 7407 tomorrow, and if good start running the parallel pin outputs with a scope. Since all the signals have to come out at set times and with defined voltage levels it will be difficult to say that they are good not knowing the programming algorithm. I am getting too side tracked with this considering knowledge and equipment. The supply voltages are OK and it looks like if it's a hardware issue it will be the laptop. I will install the software into the work station tomorrow and compare. Later I'm out of here.
Bookmarks