New user with PAUSE command problem

[Dwayne]

Hello Howard,

Howard>>I know I must be doing something wrong here ... but for the life of can't figure what. Any help or ideas would be greatly appreciated ....<<

The pause command works great... If you can give us a water down code that shows where the pause does *not* work, maybe we can take a look at it....


Have you tried Pauseus or slower Pause command to verify?
Like Pauseus 1? then Pauseus 10 etc?

I thought I ran into something like this with the 688, until I found out the speed was set to the lowest of 34khz? And my program crawled....while I thought it was dead.

And, just to through out a few other things...Are you sure the pin you are checking is set as a output pin? Are you sure the pin you are using *IS* a i/o pin?

Are you reloading a a HEX file, instead of recompiling it and reloading it? Nothing like having a working hex file, and the code that is in the window does not match the Hex file <g>.


Dwayne