PIC 18F4550, firmware

[skimask]

Define ONINT_USED 1
LED var PORTL.0 ' Alias PORTB.0 to LED
loop: High LED ' Turn on LED connected to PORTL.0
Pause 500 ' Delay for .5 seconds
Low LED ' Turn off LED connected to PORTL.0
Pause 500 ' Delay for .5 seconds
Goto loop
End
This is a simple example from the guide.
Do I need to define anythin further? osc 20mhz?

PBP 2.46

Which page is 'Define ONINT_USED 1' on in the guide?

And since when does a PIC18F4550 have a PortL?

[kutsi]

PORTL.0 is a user defined variable for PORTB.0
PAGE 6

[skimask]

PORTL.0 is a user defined variable for PORTB.0
PAGE 6

It is? That's a good trick! How about this...
PortL encompasses pins 0 - 7 (PortB for a 40 pin PIC), and PortH encompasses pins 8-15 (PortC for 40 pin PIC).
At least they do according to pg.26 and 27 (section 4.11).

Now then, how about the rest of the questions...again...

[kutsi]

PBP 2.46
mplab ICD 2 as programmer
mplab IDE 7.5

anything missing?

[skimask]

PBP 2.46
mplab ICD 2 as programmer
mplab IDE 7.5

anything missing?

Yep...see post #6...
What does 'Define ONINT_USED 1' mean?

[kutsi]

I don't know exactly what it means. Actually this is a sample code from PBP. The name is Blink.bas

[skimask]

I don't know exactly what it means. Actually this is a sample code from PBP. The name is Blink.bas

And it probably says it was written for an older version of PBP.
If you do a search here for ONINT_USED, you'll see why that isn't going to work for you...