PIC16F88 senior design

Results 1 to 40 of 72

Threaded View

  1. - 25th April 2007, 23:42 #11
    skimask's Avatar
    skimask Guest

    Default

    Quote Originally Posted by AlaskanEE View Post
    DEFINE LCD_LINES 2
    If you are using a parallel mode LCD (Hitachi 44780 based), then PBP requires quite a few more defines to get it to work (see the manual).
    If you are using a serial mode LCD (usually a parallel LCD mounted on a PCB with another PIC doing the decoding duties), then the DEFINE shown above isn't going to do anything for you. And you'll want to refer to the manual for the LCD.
    And it would most likely help a lot if we knew what kind of LCD you were using...
    Get the manual! And read it! We can help you with a lot of stuff...but again...I, for one, am not into hand-holding.
    Last edited by skimask; - 25th April 2007 at 23:44.
« Previous Thread | Next Thread »

Similar Threads

  1. RX TX modules - intermitent communication
    By ruijc in forum mel PIC BASIC Pro
    Replies: 13
    Last Post: - 11th June 2009, 00:13
  2. pic16f88 & voltage
    By rdxbam in forum mel PIC BASIC Pro
    Replies: 10
    Last Post: - 17th February 2009, 09:14
  3. Ghange code from PIC16F877A to PIC16F88
    By savnik in forum mel PIC BASIC Pro
    Replies: 2
    Last Post: - 12th March 2008, 16:09
  4. Erratic behavior with a PIC16F88 and an custom LCD Board
    By russman613 in forum Schematics
    Replies: 8
    Last Post: - 7th December 2006, 15:42
  5. PIC16F88 problem with TOGGLE command?
    By russman613 in forum mel PIC BASIC Pro
    Replies: 2
    Last Post: - 17th September 2006, 23:31

Members who have read this thread : 0

You do not have permission to view the list of names.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules