never seen wireless cams at walmart.. gonna have to go tomorrow... i already have some wireless cams though, and one of them is a lot more powerful than most of the "consumer" ones.. its great havin a "ham" license...

i tried welding the cleats to the chain, but it wrecked the "bearings" in it, and so the chain couldnt "flex" very well. the bolts work great, i used to have 3/4" ones on every second cleat, and there was no way it would slide then. it had some trouble turning though because of it, and it scratched the driveway pretty good.

so do ineed the cap in on the MCLR to ground? or should i just leave it in??

my chip has a max speed of 40mhz but all i have is 20mhz resonators. most equipment on the board is meant to use serial commands at 2400 to 9600 baud. i would also like to experiment with some mapping. would it be worth it for me to run it higher than 20mhz, or do you think it will be fine?