Hi all,
Yeh, I am in the same boat as well.
New laptop, Vista Home Premium.
Ive installed from cd Microcode Studio Plus 2.3.0.0
The Complier (PBP 2.45), Assembler (MPASM) and Programmer (Epic 2.44) have all been setup in ... View/Compile and Program options.... area.

When I run the Microcode Studio Plus program I get this little error message popup.....
" List index out of bounds (11) "
and the program closes.
I run it a second time and it loads up ok,
so I open a *.bas file and try a complie (with the correct chip file eg: p16f876a)
Then I get THIS error popup.....
" Cannot create file run.bat. "

ANY advice will be most welcome,

regards
Shaun Woods