I set the fuses finally. The brown out reset voltage fuse is _BORV_21_2L, found this looking through the lst file. Now nothing seems to work, not even simple LED flashes. I have no idea what is going on.
I set the fuses finally. The brown out reset voltage fuse is _BORV_21_2L, found this looking through the lst file. Now nothing seems to work, not even simple LED flashes. I have no idea what is going on.
Now that you get "nothing". It seems like FCMEM_OFF is doing it's job, and now it's not running on the internal oscillator.
I think your problem might be the 33pf caps on the crystal. Or a bad/wrong crystal.
The datasheet shows that it should be around 22pf for 20mhz.
With FCMEM_ON, the chip will switch over to the internal oscillator if the primary isn't working. You'll see LED's blink, but it's not the right frequency for USB to work.
___________
DT
Q. Why do they put braille on the number pads of drive-through bank machines?
Q. Why do they put Braille on the number pads of drive-through bank machines?
A. The manufacture of the number pads on bank machines, have Braille on the numbers. Whether it is a drive through or walk up. It would be expensive to change the number pads on drive through machines, or put the braille enhanced number pads on walk up. The buttons being mass produced, are put on all of the number pads, no matter where they are located.
Source:http://www.confusionwithin.us/docofbs/?p=11
Wisdom is knowing what path to take next... Integrity is taking it.
Ryan Miller
Okay I finally got it to work!
I had to set the fuse values in melabs serial programmer as well as the fuses in the config files. I didn't know the programmer would rewrite the config values from picbasic pro.
Thanks for the help guys!
Bookmarks