Quote Originally Posted by aftab View Post
I did that, but it does not work.
Do I need to do special coding (peek,poke,srout,...) to do an ICSP ?
Somewhere in JDM programmer, it says the voltage goes upto 13v.
I am no electronic geek - so do not understand much.
Any clue what might be the problem ?
Thanks
Aftab
You probably have to add another header or something to cutoff the outside signals going to the 24xxxx itself. You're probably trying to feed power/signals to the whole board, not just the 24xxx, PIC fires up, signals start interfering with each other, etc. Try pulling other chips out, etc.
The JDM programmer voltage is only for the PIC (or maybe other MCU's). 13v would most likely kill a 24xxx.