LCDOUT probs

[hoopstar]

Charles,

Is there any particular reason that the 4 data bits and the controlling pins (ie. E, RW, RS) should be on different ports as I seem to see in most examples??

Or can they be "defined" to the same port without problem?


Hoops

[Charles Linquis]

They can be defined on the same port. The only limitation that I'm aware of is that the DATA lines must start on a nybble boundary (either on bit 0 or 4)of a port.

[Jhdgkss]

hi thanks for your replys.
so to alter this code to run on a pic16h84 witch has o port h only A and B i make the following changes

start:
DEFINE LCD_DREG PORTA
DEFINE LCD_DBIT 0
DEFINE LCD_RSREG PORTA
DEFINE LCD_RSBIT 4
DEFINE LCD_EREG PORTB
DEFINE LCD_EBIT 3
DEFINE LCD_RWREG PORTA
DEFINE LCD_RWBIT 4
DEFINE LCD_BITS 4
DEFINE LCD_LINES 2
DEFINE LCD_COMMANDUS 3000
DEFINE LCD_DATAUS 300

Main:

pause 1000

LCDOUT $FE, 1
LCDOUT $FE, 2, “Hello”
pause 1000
goto Main


with connections

1 - VSS
2 - VDD
3 - VC
4 - RS - PortA.4
5 - R/W - portA.4
6 - E - PortB.3
7 - Db0 -open
8- DB1 - open
9 - DB2 - open
10 DB3 - open
11 DB4 - portA.0
12 DB5 - portA.1
13 DB6 - portA.2
14 DB7 - portA.3


could some one please have a look at my data sheet for the display and check hat this setup will work with it
http://www.maplin.co.uk/Media/PDFs/N28AZ.pdf
thank you for your patience your help has shed a lot of light on the subject of lcd's for this newbie.

[mister_e]

Assuming you have a Pull-Up resistor on the PORTA.4 pin, i think you MUST set them to LOW yourself.

You don't need to use the LCD R/W pin, just ground it and remove the according DEFINEs


AND you have two things on PORTA. RW and RS

[Jhdgkss]

hi there thanks for the reply. ia have resistor on that pin

i have noticed the prob with rw and rs
here are my changes in code

start:

portA = low
PortB = low
DEFINE LCD_DREG PORTA
DEFINE LCD_DBIT 0
DEFINE LCD_RSREG PORTA
DEFINE LCD_RSBIT 4
DEFINE LCD_EREG PORTB
DEFINE LCD_EBIT 3

DEFINE LCD_BITS 4
DEFINE LCD_LINES 2
DEFINE LCD_COMMANDUS 3000
DEFINE LCD_DATAUS 300

Main:

pause 1000

LCDOUT $FE, 1
LCDOUT $FE, 2, “Hello”
pause 1000
goto Main


with connections

1 - VSS
2 - VDD
3 - VC
4 - RS - PortA.4
5 - R/W - Ground
6 - E - PortB.3
7 - Db0 -open
8- DB1 - open
9 - DB2 - open
10 DB3 - open
11 DB4 - portA.0
12 DB5 - portA.1
13 DB6 - portA.2
14 DB7 - portA.