Well I have PBP 2.6C, So I think I must have all the proper files. I copied the entire contents of the USB18 folder to a new folder. started MCS, selected PIC18F67J50. Opened cdc_demo.pbp from the new folder. Hit compile, all was fine. programed chip. plugged in USB and waited. for at least 10 seconds. no indication from PC that I had plugged it in.

Now I listed these step just to be clear that is ALL I did. If I need to move a .inf file somewhere, or anything else like that, I have not done it.

On a side note, thought I would distract myself by installing VB 2010 express. Well that has also been FAIL! I am thinking I need to throw all this new crap in the trash and bust out an old dos machine. (yes I have some) I bet PBP will even run on that.