PIC sinking voltages higher that Vdd???

[manumenzella]

Hi. First of all, I want to say sorry if this is already posted, but I tried searching with no luck. I would like to know if an IO of a PIC can source a higher voltahe than Vdd. For example: PIC running at 5v, and a piezo running from 9v unregulated directly from a battery. In this way, the piezo will sound louder, right???

Also, i think i might need to use a small diode in the IO, because, even if the IO is high , there will be some voltage difference with the battery voltage, and the piezo will never come back to the "resting" position, right.

Thanks for your work, and sorry for my english.
Manuel

[skimask]

Hi. First of all, I want to say sorry if this is already posted, but I tried searching with no luck. I would like to know if an IO of a PIC can source a higher voltahe than Vdd. For example: PIC running at 5v, and a piezo running from 9v unregulated directly from a battery. In this way, the piezo will sound louder, right???

Also, i think i might need to use a small diode in the IO, because, even if the IO is high , there will be some voltage difference with the battery voltage, and the piezo will never come back to the "resting" position, right.

Thanks for your work, and sorry for my english.
Manuel

Look on any PIC datasheet...do a search for the term "Electrical Characteristics", there you will find your answer.

[manumenzella]

Thanks a lot
I will look it right now!!!
Thanks again
Manuel

[manumenzella]

Hey. Sorry to bother you again.
I have just looked in Electrical Characteristics, but i cant seem to find my answer I think it might be the thing called "clamp current" or sth. but im not sure. I tried looking it up by Google without any luck, too.
Can you please tell me the parameter i should be looking for please???
Thanks in advance!!!!!!!!
Manuel

[Darrel Taylor]

Manuel,

All you need is a general purpose NPN transistor, and a 10k resistor.

10k from pic pin to the base, emitter to vss, collector to piezo, other side of piezo to +9V.

Setting the pin HIGH, will turn on the buzzer.

HTH,

[mister_e]

Manuel what kind of piezo do you talk about? Those 'plug and play' or those you MUST produce a tone to hear something?

For high current, Darlington can be nice in some case, but they usually switch slowly and many have a BIG voltage loss between Collector and Emitter (few volts or so). I prefer MOSFET.

[skimask]

Hey. Sorry to bother you again.
I have just looked in Electrical Characteristics, but i cant seem to find my answer I think it might be the thing called "clamp current" or sth. but im not sure. I tried looking it up by Google without any luck, too.
Can you please tell me the parameter i should be looking for please???
Thanks in advance!!!!!!!!
Manuel

1st page of that section, on the datasheets I've looked at so far, it's usually the 3rd parameter.

[malc-c]

Typing something like "driving piezo buzzer from pic micro" into Yahoo returned some interesting hits.

http://www.talkingelectronics.com/Pay/PIC/P6extra.html

I wouldn't expect the Piezo to draw much current, so a single transistor as DT suggested would be fine. If you want to drive things like motors then you could used an H-bridge or a Darlington power transistor.



For your Piezo you could omitt the 18R resistor and output transistor, and connect the buffer transistor's emmiter to the 12v (or 9v in your case) supply

More info can be found at http://www.talkingelectronics.com/Pa...PIC-Page3.html which explains the reason for using two or more transistors for high current loads.

Hope this helps