Multiple PIC's with 1 crystal

[RussMartin]

Method 3.

Use a CMOS HEX Inverter/Driver IC and build a simple conventional Oscillator (as you would do if you were building a standard non-PIC logic design. Fan this out to heaps of PICs on your PCB as each HEX inverter/buffer stage should be able to fan-out to over a dozen PICs.

My experience with these (both CMOS and TTL) is that, like Method 4, they can generate some interesting RFI, especially on the odd harmonics.

(I mean "interesting" in the sense of the ancient Chinese curse, "May you live in interesting times.")

[rossfree]

I never got an answer to this question.

I would like to share the crystal of a 16f876 with a 16f88. By the thread above, I tie osc2 from the 16f876 to osc1 on the 16f88. What about the second osc2 input on the 16f88. Do I leave that pin hanging or tie it to something?


Thank you,

Ross

[skimask]

I never got an answer to this question.

I would like to share the crystal of a 16f876 with a 16f88. By the thread above, I tie osc2 from the 16f876 to osc1 on the 16f88. What about the second osc2 input on the 16f88. Do I leave that pin hanging or tie it to something?


Thank you,

Ross

For one thing, OSC2 is usually Fosc/4 (i.e. 10mhz in = 2.5mhz out), so depending on how you have it set up, the one PIC will run 1/4 the speed of the other PIC. In any case, you try it with it hanging; it doesn't work, try a weak pull up, that doesn't work, try a weak pull up, etc. and so on and so on...

If it was me (and I've done this before), I'd get yourself one of those 4 pin oscillators, run the clock output of that into something like a 7404, tie a couple of the inputs together, and use the individual outputs to drive the seperate clocks of the PICs, which are set to external clock or HS mode. Simply put, the 7404 is used as a buffer to keep the 2 inputs from messing with each other.
Or, use a 7404 as part of a crystal oscillator circuit and take the output and run it into a couple of other inputs as suggested above.

[Dave]

rossfree, Don't listen to skimask as the OSC2 output is divided by 4 ONLY in RC mode and INTIO mode. Either of which you are using. In normal HS or XT modes the OSC1 signal is buffered and inverted on OSC2. It's all in the data sheets....

Dave Purola,
N8NTA

[skimask]

rossfree, Don't listen to skimask as the OSC2 output is divided by 4 ONLY in RC mode and INTIO mode. Either of which you are using. In normal HS or XT modes the OSC1 signal is buffered and inverted on OSC2. It's all in the data sheets....

Dave Purola,
N8NTA

Right, don't listen to me...sometimes I don't know what I'm talking about....like in the above post

[rossfree]

Thank you... I was a bit puzzled...

Which brings me back to the original question...

Do I tie off osc2 on the second PIC or leave it unattached??? Looking for a simple answer. :-)

Ross

[Melanie]

Just leave it hanging (or use it as an available I/O if your particular PIC permits). If you needed to do something with it, I would have said so in my original post at the start of this thread.