Can PicBasic support 56700 serial baud?

[skimask]

Hi Skimask,

I think the PIC12F629, and PIC12F675 are supported, and they both have internal osc as well

However, I did make progress today with a 12f675.
Yup.... doing the bit-banging routine.

Just a heads up, I don't know if I'd trust that internal osc too far, at least not at some of the higher baud rates, and especially not at 57,600...maybe 9600, that would be about it. Temp, volts, etc. makes the internal osc drift too far once you get going too fast...

[mister_e]

even @ 2400 baud, some PIC may don't work. Unless you want to waste your time to fine tune the internal osc (don't remind if you can do it with those 629 or 675), you should think of using a external crystal or a ceramic resonator.

[dw_picbasic]

Well so far so good ( at least sending to the device) with just the little 12F675. I put the bit/byte patterns into eeprom and read them into bitstream output for each requested command to the device.
I built a control switch pad this weekend using A/D on one pin.
My next step is to include an encoded POT output device to control a second piece of equipment at the same time. I have two pins left..... oh boy !!

These chips is fun!!