ESC problem plz help

[paulvits]

I have used several time the M33033 and the M33035 from Motorola. It very simple to conect these with a pic.
The only connection are.
+5v or gnd for the direction
5v for enable input
0 to 5Volts for speed.

[Acetronics2]

I have used several time the M33033 and the M33035 from Motorola. It very simple to conect these with a pic.
The only connection are.
+5v or gnd for the direction
5v for enable input
0 to 5Volts for speed.

Hi,Paulvits

The translated question was " how to generate 1 - 2 ms, 5v pulses @ ~ 50 Hz " ...

not to create a brand new controller...

Alain

[al000y]

thnx for all of you

what i understand from you guys
that i must generate 1 - 2 ms PPM signal to the ESC

to generate the signal i must build a servo pulser

so which one better this http://www.uoguelph.ca/~antoon/gadgets/servo3.gif
or the one in the attach?

[Acetronics2]

Hi Al

Mine ...( The second !!! ) works fine and is simple to realize ...

but all "555 " designs are to be used without fear !!!

Alain

[al000y]

hey
Acetronics i know you get bored from me but i swear its the last question



after i build the servo pulser
i should conect the red wire one the ESC to the + wire one the servo pulser
and the brown to - and the orange to the signal and it(the motor) will work without a receiver right?

[Acetronics2]

hey
Acetronics i know you get bored from me but i swear its the last question

> do not think you can do it so quickly !!! being boring only comes from stupid questions ... not from lack of knowlege !!!



after i build the servo pulser
i should conect the red wire one the ESC to the + wire one the servo pulser
and the brown to - and the orange to the signal and it(the motor) will work without a receiver right?

Seems right ... which brand is your ESC ???... just to be sure !!!

Alain

[al000y]

this one
http://www2.towerhobbies.com/cgi-bin...&I=LXKSY4&P=ML