18F2510 help

[peterdeco1]

Hello Everyone. I recently added code to a program compiled for a 16F76 and it wouldn't fit in the PIC. So I compiled it for a 18F2510 and the timing seems to be off. Certain sections of the code seem to run slower while other sections run a little too fast. Does anyone have any suggestions? I changed adcon1 = 7 to adcon1 = 15 for the 18F PIC. I also had to remove my @device line to compile without errors. I then set the config bits within MPLAB before programming. Thank you.

[mister_e]

Just make sure that all register match from one to another. Sometimes, some specific bits on a device are not located at the same place on another one.

If you don't mind, post your code here.

[peterdeco1]

Thanks Steve. One interesting thing is the beginning of the program runs slow - delays that are supposed to last only 1/2 second take 2 seconds to complete. I was able to eliminate this by changing the Watchdog Postscaler from it's default of 1:128 to 1:8. However, later in the program there are delays that are supposed to last up to 6 seconds but finish in about 4-1/2 seconds. Any ideas?? - Thank you.

[mister_e]

I didn't check the datasheet but, are you using the internal OSC (if there's) ?

try the eternal Led Blink first and post your observations here.

[peterdeco1]

Hi Steve. The circuit uses a 4MHZ ceramic resonator. Again, the 16F76 worked perfectly until I compiled it for 18F2510. I must be missing something???

[Ron Marcus]

Hi Steve. The circuit uses a 4MHZ ceramic resonator. Again, the 16F76 worked perfectly until I compiled it for 18F2510. I must be missing something???

How are you implementing the delays?

[mister_e]

Weird,
your ADCON setting is good, the comparator are off at POR... so...

Any way to post your config fuses setting here?