Serin serout problem

[skimask]

O my I changed to this
serin portB.2 , t2400 , [ temp.highbyte , temp.lowbyte , tempf.highbyte , tempf.lowbyte ]

now the temp is showing up on first line, BUT is it showing zeros,
incrementation on try, try2 fixed at 0

check the web page also, for output on lcd

also:
On the receiver side...
Change the word 'Waiting..' to
'Wait 4 it'
and see what happens ----------- Only the display changed

receiver side change - That's what I was wondering. I had a case a couple days ago where I thought it was programming, but the PGD wire had come loose from my board, so it wasn't actually programming, even though it didn't report any errors (and I had my verify turned off!).

Changing to t2400 is going to do exactly what you saw. But it doesn't fix anything. Leave it at n2400, or try changing both sides to t2400.

And try putting a small resistor inline with the big yellow wire, about 100 ohms or so. Without it, it's almost like a direct short from power to ground from one PIC to another. I should've caught this earlier.