that is the data, serout going to the input pin of the other circuit
i also tried an f648a, nothing on the lcd
k
|
that is the data, serout going to the input pin of the other circuit
i also tried an f648a, nothing on the lcd
k
Last edited by lerameur; - 24th December 2006 at 03:11.
|
I just flip the circuit around, I mean take the receiving chip put it in the sending circuit and flip the other chip around, Then I just plug in the input wire to the new receiving chip.
Same output as before. The receiving LCD just sits there
|
Ok, I'm back...the relatives showed up for a bit...had to deal with them...Originally Posted by lerameur
Your programs:
Transmit side - output is on RB2, correct?
Receive side - input on RB3, correct?
And the big yellow wire is the data wire right?
Last edited by skimask; - 24th December 2006 at 04:15.
|
yes that sit,
Its hard to belive it works on your end.
thats ok , i was watching mad tv...
|
Well, do me a favor....
Take that big yellow wire, follow it to the PIC on the right.
Consult your datasheet, and tell me what pin it goes to.
Then take that same big fat yellow wire, follow it to the PIC on the left, consult your datasheet, tell me what pin that goes to....and fix it!
|
in the picture I had just finish trying all the B ports., It was in RB6, which was the last of the port I tried
the sending IS on RB2
and Receiving is on RB3
go back to the web site i posted a new picture
Last edited by lerameur; - 24th December 2006 at 05:00.
|
Then put up a fresh picture and change your receiver to portb.2
|
Ok so now both receiver and transmitter are on portb.2
the picture is up
would the problem be in the software, is the pic16f88 special and need extra attention ?
Last edited by lerameur; - 24th December 2006 at 05:21.
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks