Switch LCD OFF during sleep, possible?

[sougata]

Hi,

If you are powering your LCD you need to re-initialize the LCD. PBP would do that for you when it encounters the next LCDOUT instruction. All you need to do is

FLAGS=0

This will guide PBP LCD library that the LCD has not yet been initialized.

[flotulopex]

I don't understand.

If you are powering your LCD...

Do you mean this if I power the LCD through a PIC's Pin ?

Shall I set FLAG=0 when I come back from sleep mode?

[Ioannis]

Look at page 93 of the latest manual. It is FLAGS (with S) not FLAG.

If you power down your LCD, also set FLAGS=0. Before using any LCDout commands.

Ioannis

[flotulopex]

Thank you.

I found it now too...

Didn't think this was important.

[sougata]

Hi,

I hope that it is clear now. And thanks Ioannis for marking flutoplex's mistake.

[Ioannis]

Hi Sougata,

you are welcome. A simple typo mistake can lead to many hours of wasted time. Been there before....

Ioannis