Advice please - Warning message

[malc-c]

Steve,

I've pointed the programmer to the correct path of the DEV files and it made no difference. ( as you can see no message saying it can't find the file)

Programming...
Erasing ("bulk" or "chip") ...
Programming CODE, 0x000000..0x0000B4
Verifying CODE, 0x000000..0x0000B4
Verifying 0x000000..0x0000B4
Programming CONFIG, 0x300000..0x300006
Verifying CONFIG, 0x300000..0x300006
Verifying 0x300000..0x300006
Verify Error: 300000: read 000000, wanted 0030C0, mask 00FFFF ==> diff=0030C0
Verify Error: 300002: read 000E3E, wanted 00CEFE, mask 00FFFF ==> diff=00C0C0
Verify Error: 300004: read 008000, wanted 00F8FF, mask 00FFFF ==> diff=0078FF
Verify Error: 300006: read 0000A1, wanted 00FFBB, mask 00FFFF ==> diff=00FF1A
ERROR: Programming FAILED !

I also typed in the "30C0 and CEFE" into the first two config memory locations and tryed programming that - it errored as before.

I've had this programmer working as I've used it to program USB RC-Joystick file, but I've juts tried that code and it too errored. The only difference is I'm now using XP Home and SP2, but I'm sure that would have no bearing on this issue ?

Malc

EDIT - oh and this was the third and last 18F2550 PIC I had 0 fresh out of the tube !