Thanks to everyone that responded. Its been great.

This project is for a fuel injected rideon. i have compleded an analogue circuit and it works ok. but i am not 100% happy with it. the o2 sensor is sensing if the engine is rich or lean. the pic's (16f877a @ 20MhZ) job is to make sure it stays correct at 14.7 with injecting the correct amount of fuel at its given RPM / LOAD thats why i am needing a table.

The max rpm the engine will do is 3600

Is there any way to make the table bigger than 16 X 16
ie 64 X 64?


thanking all in advance