1. What hardware do you have? List the PICs, the crystals, the LEDs, the TX, the RX, the switches, the pot, etc. and so and so....
Pic16F88, 20Mhz crystals, Led out on portA.0,1,2 and 3
MCRL on PORTA.5, ground pin, Vdd on 5v. NO pot, no switch, Just a wire going from PortB3 (output of serout) going to portA.4 (serin)
if serin.. well
START:
B0 =0
serout portB.3,n2400, [ $0F, $0F, $0F, $0F, $0F, $0F, $0F ]
serin portA.4,n2400, [B0 ]
if (B0 = $0F) then
porta.2 =1
pause 100
porta.2 =0
else
goto start
endif
GOTO START

2. What is your 'master plan'? Do you intend to transfer data between 2 PICs wirelessly? Do you intend to just control a couple of LEDs wirelessly? What?
I want to transfer data to about 200feet between two pics.

Go back to my web site, I posted a picture of the circuit
thanks for your time
ken