Hello Ron,

Thanks a millon for coming to my rescue. Well a few things I need to understand is what is the sequence to transmit a particular byte thru these modules and What is the sequence to set the Module in receive mode. As you said , there is a lot of grey area in the datasheet , which only explains on how to program the registers. Well I have successfully been able to program the registers and all that what is said on the top.

OK some inputs to your suggestion. I have been able to transmit some 15 bytes using the method I explained in my previous thread and for sure , I have monitored these signal on my R1 Scanner Receiver.

How do I
1. Program the registers for continous transmisson.
2. How do I program the PA_Table. Is it necessary.
3. In the abscence of GD0 and GD1 Pins How do I provide an interupt to the MCU for a received packet in the buffer.

I have many more question to ask, but I just don't want to bother you on that.

regards


p.s. I have the Code for the Manufacturer's demo Board in "C" but don't understand Head "NOR" Tail from it. If it helps you , I can send it to you. I just understood that the manufacturer sends the packet at different PA level for possibility that the module is just to near to each other and likewise. More on this later.