Hi Joe S.

I really am trying to figure out how to offer some help to you. I too have had a problem using serial LCD's in the past. I have one from SEETRON, a 2x16 that has served me well in the past few years. I don't understand why it should take a "special" type of serial adaptor for every type of project though. The only difference between setups is the baud rate that I can see. You use either 2400 or 9600. The difference is on the PIC side. If you are going to do any serial data out, you really should use an external crystal or resonator. This is because the PIC's internal clock isn't always accurate for the higher baud rates. This fact has been stated many times in the past on the various forums here. Your PIC only needs the statement: "SEROUT GPIO.0,6,[72,72,58,77,77] 'Display HH:MM", for example, to get data to the display. Obviously, the PIC must be configured for the baud rate. (I took the statement from Paul Borgmeier's Easy Clock program). There is far less setup and PIC pin usage with a serial display than with a parallel display so I think that's why they are shown more than the parallel displays. As for someone specifying certain types of backpacks, it shouldn't matter. All you are doing is sending serial data out at a certain rate. Most backpacks have jumper selectable baud rates.

You should be able to buy a couple of backpacks, keep them in a parts drawer, then when you need one, plug in the LCD and away you go. I just bought 4 from a place called Wulfeden for a reasonable price and I have them available when I need them. I have been mostly been using 4 x 20 VFDs on a few larger projects. I bought a dozen of Melanie's Blue 2 x 16 LCDs last year and they are great for adding the backpack to. You don't need to solder the backpack to the LCD. Just use plugable headers. So If you go from parallel to serial you just plug in the backpack and away you go.

I hope this helps.

BobK