Problem with LCD and Start Up

[savnik]

After defining the lcd you must place a pause of about 500 msec.
This is nessesary to give the lcd a chanche to setup and set all registers insite ok, before receiving de lcd data for the screen.

I have test this :
Pause 250 ' Delay for LCD to power up
and this :
Pause 1000 ' Delay for LCD to power up
but nothing.
The problem is the same.
I understand , that my problem is the reset on pin 4 (i test 4.7k-10k-33k)
If i delay the reset on pin 4 for 4 and up secs all work ok.