Bitwise not working

[mister_e]

As the pin are set to input.... if you write to them, the result stay unchanged... as i posted. Not sure with the interrupt.

Why do you think that PORTB.7=1 or PORTB.7=0 no nothing if the TRIS.7 is not set to 0?

One thing is sure, you will clear the RBIF bit just by reading PORTB, so the above solution using Temp=PORTB will certainely cause some strange interrupt behaviour (at least you will miss some). All in the datasheet in INTCON register description.

[Ioannis]

Steve, yes I know reading the port, RBIF will get reset. But what about writing to the port if the upper nibble is input? Will the write cause Interrupt?

I can tolerate to loose a few while writing to the port. But producing Int's for this reason is not welcome.

Sayzer, nice idea the old recipe. I am just looking too shorten my code. I 'll see which method is shortest.


Thanks,
Ioannis

[paul borgmeier]

Both “Temp = PortB” and “PortB = i” read the Port . Both allow for a chance of missing a change and therefore an interrupt. Steve is right in that preserving the state of the upper four pins does not appear necessary since it does not change the input values when the port is written – just the latched values should the pin directions be changed from inputs to outputs. Go with #5.

[Ioannis]

OK guys. I thought of preservint the interrupts. Anyway, sometimes your thoughts are silly without the ability to see further...

Thanks,
Ioannis