Remote Control receiver - input source switching

[octavio bru]

I just finish my. using part of this proyect.

h t t p : //www.web-ee.com/Schematics/VSwitch/vswitch.htm

the only part i change was the software, i use some ir RC5 library from this book Experimenting with the PicBasic Pro compiler.


h t t p : //developersbooks.com/ebooks/viewbook/38/17/1.html

now im working to add some OSD.

i hope this help.

I am sorry to say that I do have this book, it was my first one about PicBasic Pro, and there are no RC5 routines in it. Unless there is a new edition and they have been included. Can you check that?

I have been looking for an easy to use RC5 library and haven't found any.

Thanks in advance

[cesarman]

mmm, sorry you rigth only for sony protocols. no RC5, well the only basic compiler is proton. Version 3.X, has RC5 fuction. Tested

Example

Device = 16F877
RC5IN_PIN = PORTC.0 ' Choose the port and pin for the infrared sensor
DIM RC5_WORD as WORD ' Create a WORD variable to receive the data
DIM RC5_COMMAND as RC5_WORD.Lowbyte ' Alias the COMMAND byte to RC5_WORD low byte
DIM RC5_SYSTEM as RC5_WORD.Highbyte ' Alias the COMMAND byte to RC5_WORD high byte

ALL_DIGITAL = ON ' Make all pins digital mode
Cls ' Clear the LCD
While 1 = 1 ' Create an infinite loop
Repeat
RC5_WORD = RC5In ' Receive a signal from the infrared sensor
Until RC5_COMMAND<> 255 ' Keep looking until a valid header found
Print at 1,1,"SYSTEM ",Dec RC5_SYSTEM," " ' Display the SYSTEM value
Print at 2,1,"COMMAND ",Dec RC5_COMMAND," " ' Display the COMMAND value
Wend