HPWM will handle it for you. if 8 bit resolution is enough, it's the easiest way.
|
HPWM will handle it for you. if 8 bit resolution is enough, it's the easiest way.
Steve
It's not a bug, it's a random feature.
There's no problem, only learning opportunities.
|
I've tried a lot with piezo-summers... (without any circuit in them!)!
Forget it !
Buy readymade Piezo-beepers for intrusion-detection !
Piezo-beepers are allowed to have 24 Volt accross them. So I have used a circuit to double the power (5V -> 10V) with one pin of the PIC and loaded a 1000uF condensator. Then I use a MOSFET-driver ICL7667 to drive the beeper from this 10V. It is loader, but using some cheap magnetic beepers from digisound is much more easy....
;-)
PBP 2.50C, MCS+ 3.0.0.5, MPLAB 8, MPASM 5.14, ASIX Presto, PoScope, mE mikroBasic V7.2, PICKIT2
|
BigWumpus,
Do you have a part number or a particular place where I can purchase a ready made piezo-beeper? thanks.
|
Digisound F/UCW 03 or ...06
PBP 2.50C, MCS+ 3.0.0.5, MPLAB 8, MPASM 5.14, ASIX Presto, PoScope, mE mikroBasic V7.2, PICKIT2
|
Hi everyone,
I finally got a PIC with HPWM. Is there anything else I have to setup aside from the ccp1con? Thanks
|
Which pic is it?
PR2, T2CON are others most likely.
----------------------
"If the Earth were a single state, Istanbul would be its capital." Napoleon Bonaparte
|
Hi sayzer,
its a 18f1320 with the HPWM without the HPWM 16f88. thanks
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks