Am I at all close? I can get it to compile without it but adding a
"For HPWMFREQ2 leaves me in the dark as two FOR NEXT loops is not correct but both timers need to change frequency at the same time. Thanks again to the best support group I've ever known!


DEFINE LOADER_USED 1
DEFINE ONINT_USED 1
DEFINE OSC 10
DEFINE CCP1_REG PORTC 'Hpwm 1 pin port pin 17 rc2 ccp1
DEFINE CCP1_BIT 2 'Hpwm 1 pin bit
DEFINE ADC_BITS 12 ' Set number of bits in result 8-10-12
DEFINE ADC_CLOCK 3 ' Set clock source (rc = 3)
DEFINE ADC_SAMPLEUS 500 ' Set sampling time in microseconds


HPWMFREQ VAR WORD
HPWMFREQ2 VAR WORD
DUTY VAR BYTE
DUTY2 VAR BYTE

CNTRL var word 'ADC BEGINNING SAMPLE
TST var word 'ADC COMPARISON SAMPLE

HPWMFREQ=1500 'CURRENT FREQUENCY OF HPWM
HPWMFREQ2=3000 'CURRENT FREQUENCY OF HPWM
CNTRL=0 'ADC CONTROL
TST=0 'ADC TEST SAMPLE
TRISA = 255 'ADC Set PORTA to all input
ADCON1 = 2

BEGIN:
hpwm 1,DUTY, HPWMFREQ
HPWM 2,DUTY2,HPWMFREQ2 'OR HPWMFREQ/2?
ADCIN 0, CNTRL
For HPWMFREQ = 1500 To 2000 Step 100
'FOR HPWMFREQ2=3000 to 4000 Step 200
DUTY=65
DUTY2 = 65
HPWMFREQ=HPWMFREQ+1
HPWMFREQ2=HPWMFREQ2+1
ADCIN 0, CNTRL
ADCIN 0, TST
IF TST < CNTRL THEN
HPWMFREQ=HPWMFREQ +1
HPWMFREQ2=HPWMFREQ2+1
Endif
ADCIN 0, TST
if TST >= CNTRL then
HPWMFREQ=HPWMFREQ +1
HPWMFREQ2=HPWMFREQ2+1
ENDIF
NEXT HPWMFREQ
goto BEGIN:
end