Rc signal help

[malc-c]

I've changed your code a bit to make a simple RC Switch that turns on GPIO.1 in real time (ie activate the switch on the TX and the LED lights or goes out)

I've also removed some parts that are not needed (input GPIO.3 for example as PULSIN automatically makes the pin an input)

'12F675
@ __CONFIG _INTRC_OSC_CLKOUT & _WDT_OFF & _MCLRE_OFF & _CP_OFF
OPTION_REG.5 = 0                                                       

Pulselen   var Byte                                                   
HighCode   Var Byte
LowCode    Var Byte
clear
highcode = 0 ' setup vars to be changed
lowcode = 200 ' setup vars to be changed
                                                          

ReadPWM:
PulsIn GPIO.3, 1,Pulselen                 
If pulselen > highcode then Highcode = Pulselen 
If pulselen < LowCode and Pulselen > 50 then Lowcode = Pulselen 
if (Pulselen + 20) >= highcode then High GPIO.1                                                      
If (Pulselen - 20) <= LowCode Then low GPIO.1                                                   	    
GoTo ReadPWM

Good result for the end of the day.

[geckogrotto]

There ya go thanks for the help didn't notice the 2nd page or would have replied sooner