OMG I broke it ! (page boundary error)

[sinoteq]

relax. It was "broken" from the start. It is just an information warning thing that you can ignore unless you write ASM routines. Search the forum and you will get more information if you like. There is also a way to turn this warning off but ignore is more easy.

[Dave]

f_lez, Just make sure if you are using any BRANCH statements that you use BRANCHL instead. Like sinoteq said it's only a warning..

Dave Purola,
N8NTA

[f_lez]

Oh thanks I have just spent last hour removing all my error reporting to serout and swapped it all to a number of led flashes to save space!

Thing is I would have had to that for my finished project anyway, as it wont have a PC strapped ot it, so I've not lost anything/time etc


When I get this done, hopefully by end of week, I'l have to post it on here because as a 2nd project its not going too bad.....