Re-Writing IF-THEN-AND-ENDIF code?

[paul borgmeier]

Although I have not dove into the logic, this could be part of your issues ...

Darrel's Code Snippet

IF Seconds = 0 AND Minutes = 0 AND Hours = 0 AND _
   Seconds_Alarm_Set_Point = 0 AND _
   Minutes_Alarm_Set_Point = 0 AND _
    Hours_Alarm_Set_Point = 0 THEN  
ELSE 'If above code is true then don't check the code below 
 ...

Darrel's code goes to "ELSE" if any of the above are not true

Your Code Snippet

IF Seconds = 0 THEN 
 IF Minutes = 0 THEN 
  IF Hours = 0 THEN
   IF Seconds_Alarm_Set_Point = 0 THEN
    IF Minutes_Alarm_Set_Point = 0 THEN
     IF Hours_Alarm_Set_Point = 0 then
     ELSE 'If above code is true then don't check the code below
 ...

Yours goes to ELSE only if Hours_Alarm_Set_Point =0 is not true, otherwise they go to ENDIF and out of the massive IF-THEN jungle