Inn addition to mister_e's,
1. if you are able to turn off MCLR , then turn it off.
If not, put a 47K pot on MCLR pin and adjust it until your problem goes away.
2. Also, use BOD_OFF in config.
You will most likely solve the problem just by doing this.
3. With BOD_OFF, you can even use the PIC on the same power supply. I am using 16F628A PWM to drive IRFZ44 on the same power supply and the motor is pulling 9A at its max. No problem at all.
Last edited by sayzer; - 9th August 2006 at 08:12.
"If the Earth were a single state, Istanbul would be its capital." Napoleon Bonaparte
Bookmarks