Lcd

[savnik]

I have this defines in my code:

DEFINE LCD_DREG PORTB 'Selection of the port B
DEFINE LCD_DBIT 0 'Selection one RB0 with RB3
DEFINE LCD_RSREG PORTA 'RS on port A
DEFINE LCD_RSBIT 2 'RS on RA2
DEFINE LCD_EREG PORTA 'E on port A
DEFINE LCD_EBIT 3 'E on RA3
DEFINE LCD_BITS 4 'Mode 4 bits
DEFINE LCD_LINES 2 '2 lines

Which is the difference if add this code:

DEFINE LCD_COMMANDUS 2000 ' Command Delay (uS)
DEFINE LCD_DATAUS 50 ' Data Delay (uS)

[paul borgmeier]

...Which is the difference if add this code:

DEFINE LCD_COMMANDUS 2000 ' Command Delay (uS)
DEFINE LCD_DATAUS 50 ' Data Delay (uS)

Actually, NOTHING - these two lines as written are the default values already defined in the library file.

However, if your display for some reason cannot keep up with PIC's command issuing speed, you can increase the LCD_COMMANDUS term. If your display for some reason cannot keep up with your PIC's data issuing speed, you can increase the LCD_DATAUS term. These two conditions might happen when you run your PIC at "higher" clock rates (e.g., 20MHz) - it depends on your particular display. You also can decrease the values if you run your PIC at "slow" speeds.

So ... if you are running at higher speeds and the LCDOUT appears not to work, you can increase these values until the command works (provided this is the problem as to why it is not working ).

Paul Borgmeier
Salt Lake City, Utah
USA

[savnik]

Thank you for your answer.
PIC clock is 4 MHZ. Sometimes only when power up the pic the Lcd is not show correct.

[mister_e]

you may need to add a LCD start up delay. Something between 500mSec to 2Sec in worst case.

Be sure that your PIC don't have any Analog stuff on the pins you're using. If so, you must disable it.

That could be the issue

[savnik]

you may need to add a LCD start up delay. Something between 500mSec to 2Sec in worst case.

Be sure that your PIC don't have any Analog stuff on the pins you're using. If so, you must disable it.

That could be the issue

MY code is:

DEFINE LCD_DREG PORTB 'Selection of the port B
DEFINE LCD_DBIT 0 'Selection one RB0 with RB3
DEFINE LCD_RSREG PORTA 'RS on port A
DEFINE LCD_RSBIT 2 'RS on RA2
DEFINE LCD_EREG PORTA 'E on port A
DEFINE LCD_EBIT 3 'E on RA3
DEFINE LCD_BITS 4 'Mode 4 bits
DEFINE LCD_LINES 2 '2 lines

ADDR1=$C2

PAUSE 100

LCDOUT $FE, 1 ' Clear LCD screen
LCDOUT "TUNER VHF - UHF" ' post text during 2 second
LCDOUT $FE,$C0
LCDOUT " LESVOS "
PAUSE 2000



EEPROM 0,[$0,$0]

How to add start up delay for the LCD;

[savnik]

any help ;