Is "PAUSE 0" a valid command

[Acetronics2]

Hi,

Made some trails this morning ( 16F628 @4Mhz, internal Clock )

While m_a



outp = 1
Pause 0
outp = 0
Pauseus 100


Wend

Result is a beautiful 18.2 ... µS High pulse. ( @ 4Mhz !!! ) ( The bypass .1µF cap effect clearly shown ...)

as expected, it's not so far from Pauseus minimum duration ...

Keep in mind this "Ghost" pulses can easily trigger an unwanted event ... an a special test on the 0 value might be added.


Alain

PS for Bob : you might give a cup of strong coffee to your scope ... reading a 2 or 3 µS pulse is not that difficult for my Hameg 203-4 ( a basic 20Mhz scope aged ... 20 years these days !!! )