That's a shame, either its my browser or the plug in, but I only get audio when viewing that clip
With regards to the topic of this thread (Mel, I am trying to keep this on topic !) I hooked up a test track and placed a magnet on a loco to see how it worked, as I had been using magnets passing over the switches by hand to test the code.
I don't know if it's due to the speed of the train (slower than my hand tests) but I got a 1 in 10 success rate of both LEDs being turned off when the train exited the siding
The other question I have, is as I need 8 inputs and 8 outputs, can I use port A in the same way as port B. The thing that concerns me is the MCLR pin... do I have to do something to configure this as a normal input as I've read that this can cause problems if not treated right ??
Cheers
Malcolm
(rapidly aging and going bald by pulling my hair out over this "issue")
Bookmarks