Wrong values with COSINE!

[Eng4444]

thanks for:

http://www.emesystems.com/BS2math3.htm#arcCos

but in my application, i am not using x or y...

i am just getting a phase shift from a Phase Locked-Loop, transforming this number to degree and then, i need the cosine of this number...

All the problem is that "cosine" was made to give an answer in two's complement... and this is bad...... i need the normal answers...

[Luciano]

Hi,

From the link:
http://www.emesystems.com/BS2math3.htm#arcCos

Here is a simple demo program that illustrates the use of the SIN and COS on the BASIC Stamp. It steps through all the angles from 0 to 360. The angle is printed in degrees and the cosine and sine of the angle are printed as decimal numbers in the range of -1.00 to +1.00.

Luciano

[Eng4444]

Thanks agains Luciano,

but i really do not need them in this way... i don't mean to be rude or not caring but i really really do not need them like this..