Using ADCIN or POT/RCTIME?

[Bruce]

Hi Tony,

ADCIN & the PIC's internal ADC are actually pretty fast, but the sound
command, depending on the note/duration time, can be relatively slow.

RCTIME just measures the time a pin stays in a particular state. POT would
work, but it's really a pain to calibrate.

The time lag you're seeing is most likely due to the time it takes to generate
sound.

You can adjust the sample time for A/D readings by using the PBP
DEFINE ADC_SAMPLEUS option as long as it stays within the parameters
shown in the PIC data sheet for A/D acquisition time.

The default is 50uS unless otherwise specified with DEFINE ADC_SAMPLEUS.

[TonyA]

I see, so it's the SOUND command that's taking the time.

What about using the ADCIN with a pot using a different circuit than the voltage divider that's shown in the books. Is it possible to use other circuits with a pot and ADCIN?

Thanks again,
Tony

[Bruce]

PIC A/D inputs can be connected directly to the analog source. You don't
need any voltage dividers unless the analog input is greater than Vcc.

[TonyA]

So I can just connect one part of the pot to the pic pin and the other to ground?

Or if using a photocell, one lead to pin the other to ground?

I was laboring under the notion that there had to be that voltage divider that I've seen in some books where one pot pin goes to +5, the other to ground and the middle pin to the pic ADCIN pin.

Tony

[Bruce]

If you have an analog signal from some external device, say, a temperature
sensor or something else, that outputs an analog voltage, then you can
connect this analog source directly to the PIC A/D input.

If you're using a potentiometer to simulate the external analog signal, then of
course you'll want one end to Vcc, the other to ground, and the wiper to the
PIC A/D input.

Without one leg of the potentiometer to Vcc you wouldn't have anything but
ground on the PIC A/D input.

[mister_e]

AND be sure you POT or ELSE analog source meet the maximum A/D input impedance.

If you plan to use a PhotoResistor, you will need to pass the PhotoCell trhough an OPAmp or else method.

look the PIC datasheet (once again) to know the maximum PIC A/D impedance

[TonyA]

Ok, thanks for the info.

So RCTIME is just measuring the time for a cap to discharge, but the voltage source is coming from the pic pin itself, when it goes from low to high. In this case you would just hook the pot up like what's described for using the POT command? (None of the pots pins to Vcc)

Thanks again,
Tony