Hi, Dave
Did you try the HS setting for the clock ... some crystals are a bit lazy !!!
try also to use low value caps around ( 15 to max 27 pf )
Alain
|
Once more the 1320 ....
Hi, Dave
Did you try the HS setting for the clock ... some crystals are a bit lazy !!!
try also to use low value caps around ( 15 to max 27 pf )
Alain
************************************************** ***********************
Why insist on using 32 Bits when you're not even able to deal with the first 8 ones ??? ehhhhhh ...
************************************************** ***********************
IF there is the word "Problem" in your question ...
certainly the answer is " RTFM " or " RTFDataSheet " !!!
*****************************************
|
18F1320 xtal clock
Hi Alain...
Thanks for the response...
Unfortunately I did try changing the xtal osc feedback caps...
27pF down to 18pF... no luck...
I tried the HS setting for the CONFIG1H register as well ... no luck...
also using the HS setting in the meLabs serial programmer...
I borrowed a better O'scope...
It looks as if it's trying to start, at initial power up... but dies away..
If you have any other ideas or resources to research.. I open...
Dave
|
Dave W, If I might ask, who's crystals are you using? Do you have the spec's handy? I wouldn't giveup yet. Try putting a 1 Meg resistor across the oscin and oscout terminals with the crystal and 18pf caps in place.
Dave Purola,
N8NTA
|
18F1320 Xtal Clock
Hello Dave...
The xtal is a Citizen CM309S series...18pF Cl...
I tried the 1Mohm R across the xtal... no luck...
I also tried the series R from 10 ohm to 27 ohm... no luck
Maybe a bit more background...
Basically I have built 3 units... (I only had 3 PCB's built from the "quick turn" PCB house..)
2 worked... 1 doesn't... using the same S/W code...
but it took 6 - 18F1320 units to get the 2 working units....
That's why I thought it may have been a S/W setup problem...
The one key symptom is that the xtal osc isn't running...
This happened before... but I think because of IC swapping... it went away...
Dave W
N9DQW
|
Stupid question ...
Hi, Dave
Did you tried to read the real config settings from the chip ONCE PROGRAMMED ???
I had surprises also on this side ...
Alain
************************************************** ***********************
Why insist on using 32 Bits when you're not even able to deal with the first 8 ones ??? ehhhhhh ...
************************************************** ***********************
IF there is the word "Problem" in your question ...
certainly the answer is " RTFM " or " RTFDataSheet " !!!
*****************************************
|
Re: 18F1320 Xtal Clock
Hi !
I have to transfer a program from a pic16f628 to a PIC18F1320 enviroment..
The program runs well on the 628 but it does not on the 1320.
The prg compiles OK using PBP pro and the micro is programmed OK with ICD2 programmer.
I use a 20 Mhz XTAL osc and it is running as seen by the scope.
Any help for me to configure the new 1320 ?
Thanks in advance.
Ambrogio
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks